Landing Gear Struts, Tail Skid, and Bottom Work

Managed to get some more work done after watching The Walking Dead. Put on some more anchoring points for the rigging. Then I put on the tail skid and landing gear struts. One thing that I do not like about this otherwise cool good model is the lack of positive contact between parts. I had to drill out the tail skid hole and this resulted in a crack appearing where I had carefully sealed the fuselage.

Then I noticed the nearly non-existent holes for the gear struts had been filled
in during my painting efforts. Using my digital calipers I carefully measured the
distance between the center of the points. 

Then, after checking and rechecking the plans, I drilled holes in
the underside of the fuselage under the wing. Once this was done
I used the calipers to mark off where I should drill the other hole for each
gear strut.

A dab of crazy glue was placed in each hole and then the struts were mounted. 

Jut have to do some touch ups, rigging, and decals and it will be complete.